Automatic aluminum spacer punching machine
1. summarize
Automatic hollow glass aluminum bar punching machine, the equipment is specially used for hollow glass aluminum frame aerated components punching installation work, automatic drilling, automatic installation of aerated components.
2. Technical parameters and technical conditions
| item |
Numerical value |
| Power source |
voltage(V) |
AC220 |
| power(KW) |
0.50 |
| Working pressure (Mpa) |
0.2-0.5 |
| Component outer diameter (mm) |
5.2 |
| Overall dimensions (mm) |
complete machine |
452*400*1170 |
| Total weight (Kg) |
60 |
|
Conditions of use
(1) Gas source: The factory is required to provide an air source that can meet the working requirements of the air pressure, and the storage capacity is less than 0.30 cubic meters. Working air pressure: 0.3-0.5Mpa.
(2)Power source: single-phase AC220V, requiring stable voltage.
3. Main structure of product
The equipment includes mechanical and pneumatic and control three parts, the mechanical part mainly includes positioning part, horizontal pressing part, vertical pressing part, drilling part, top part and positioning part. The control part includes the control computer, the power switch indicator light and the intermediate relay, and the foot switch and the electric mill and the solenoid valve. The pneumatic part is mainly composed of cylinders that drive the action of each part.
4. Installation and adjustment
4.1 When the device is placed in a dry environment and the ground is level, adjust the gap between the device and the ground to ensure the stability of the device level.
4.2 Connect the power cable and the total air source.
4.3 Adjust the position of the positioning plate according to the specifications of the aluminum strip to ensure that the punching position is in the middle of the aluminum strip.
5. Use order and method
5.1 Turn on the power switch on the panel of the electric cabinet, and the red power indicator is on.
5.2 Cover the inflatable components above the lower jacking positioning head.
5.3 Lean the aluminum frame against the positioning plate, determine the hole positions, and correct them.
5.4 Step on the foot switch, and the device will automatically complete the positioning and pressing of materials, automatic drilling, and automatic insertion of components.
6. Use precautions:
6.1 For the first time, you must read the Instruction Manual in detail. If you are not clear, please call the manufacturer's service phone for consultation before using.
6.2 Do not disassemble the electric control part without the guidance of the manufacturer to avoid the occurrence of accidents, and the controller can not be casually modified to prevent short circuit burning electrical components or causing unnecessary damage.
6.3 When operating, pay attention to the position of your hands, do not place them in the area of drilling and pressing material, and pay attention to personal safety.
6.4 In case of an emergency, turn off the power switch first.
6.5 The drill bit is a wearing part. If the drilling effect is not good, replace the drill bit immediately.
Seven. Care and maintenance
7.1 It is best to install a gas filter at the outlet of compressed air to prevent the electromagnetic valve or cylinder from being damaged by stolen goods or excessive moisture in the gas, and the gas filter should be cleaned regularly.
7.2 Clean the aluminum cutting on the machine after each shift, and it is necessary to clean it when the work is interrupted, so as not to affect the normal work.
7.3 Apply anti-rust oil to the countertops regularly.
){kind=link}